Fork Re-Assembly Assistance Needed

Replacing the fork seals on an 86 Honda Magna VF700C

When I used the slide hammer technique to seperate the tube from the slider, the Rebound Spring and the flanged Sleeve popped out of the slider.

I have no clue as to what the orientation or order of these should be.

Should the Sleeve be orientated A or B (as pictured) and should it go on the tube or slider side of the retainer ring?

Also, where exactly does the rebound spring go in relation to the flanged sleeve?

I know I am not reassembling this side correctly because, with the fork tube fully extended, I am getting Figure B when I go to put the air cap on. When I originally took the air cap off, the spacer was protruding above the end of the tube as in figure A.

The left side fork is good to go and ready to be filled with fork oil. Since there is an anti-dive at the bottom of the left fork, the design is different.

The drawing in the Hayne's manual don't show the retainer clip or the flanged sleeve.

Help?

Thanks in advance. Need to get these fork back on before it gets butt biting cold (working outside on a carport.....ick)